Category: How-Tos

Intro: If you have Purchased or are in the process of purchasing an ILVE range, You may be looking for information on the range’s electrical Configuration. ILVE Range are powered by two different Voltages, Depending on the modelGas-only models: 110Volts 3 – prongElectric, Dual-Fuel & Induction: 220Volt 4 – prongSome range models: 220 Volt 4…

Triple ring burnerHigh quality italian brass

Step 1: Fully extend the storage drawer, then open the oven door.Step 2: Once the door is completely open, unlatch the door locks by lifting them toward the range.Step 3: Raise the oven door to approximately a 45-degree angle, and then lift it up and towards you. There should be little to no resistance. Step…

Step 1: Complete Pull out the problematic button, Check for any dirt, and re-insert it.

Step 1: To install the extension glides, Remove the oven rack.Step 2: Place the glides between aany of the racks tines.Step 3: Point the connectors to the end of the tines.Step 4: Push the glide to lock it in place.Step 5: Easy-glide steel oven racks make a fine accessory for any ilve rangeStep 6: It…

Tools Required: 1.Crowbar, pry bar, or hammer 2. Protective mat 3. cutting implemtent(knife, scissors, etc. 4. Wrench 5.ScrewdriverStep 1: With a crowbar, pry bar, or Hammer, pull apart the protective wood planks from their joints. Do this completely before removing each side of the wooden frame.Step 2: Pull the bottom of the outer cardboard box…

Step 1: Place the oven tray on the lowest rack to support the Rotisserie Spit Rod holders.Step 2: Place the proper end of the spit rod in the bracket. It should fit perfectly in the fitting.Step 3: If Installed properly, the Rotisserie will smoothly spin.

The Wok ring controls the heat of the burner, while stabilizing the wok when cooking.Step 1: Line up the notches on the bottom of the Wok Ring to the prongs of the grate. If placed correctly, it should be secure and not slide.Step 2: Place your Wok